Information on diagnostics

Performing troubleshooting in the secondary air system

How can you identify malfunctions in the secondary air valve? The secondary air pump is noisy – how can you check it? What causes the signs of melting on the housing of the secondary air pump? What happens if the switching relay jams? What are the consequences if the secondary air valve gets stuck? This video shows you how to check for damage on the secondary air system.

A fault in the secondary air system can usually be identified by a scratching or whistling noise, or by the secondary air pump no longer working. For vehicles with OBD, a diagnostic trouble code may also be saved in the engine control unit. 

Tip 1: Test the electrical actuation of the secondary air pump by the engine control unit and the switching relay.
The function test for the secondary air pump can be performed when the engine is cold, as the pump will then be audible for up to 90 seconds. However, the test can also be carried out with the engine at operating temperature using a diagnostic tester or an external 12 volt voltage source. If no malfunction is identified, the following problems should be ruled out: signs of melting on the housing or on the plug contacts of the secondary air pump and/or a strong smell of burning. In these cases, it is essential to replace the switching relay.


Tip 2: Frequent causes of failure are water or exhaust gas condensate in the secondary air pump. This firstly causes loud noises and then leads to failure. Clear water or rust signal a leakage between the air filter and secondary air pump. 
Tip 3: Exhaust gas condensate can only enter the pump through the secondary air valve, caused by the secondary air valve becoming stuck and no longer fully closing. You can use your finger to check whether there are any deposits. If there are deposits, this means the secondary air valve is faulty and must be replaced.
Tip 4: When it comes to pneumatically actuated secondary air valves, the solenoid valve being actuated and the vacuum should be checked. If a vacuum of at least 390 mbar is not reached, it is highly likely that there are leakages.


This might also interest you

Use of cookies and data protection

Motorservice Group uses cookies saved to your device in order to optimize and continuously improve its websites, as well as for statistical purposes. Further information on our use of cookies can be found here, together with our publication details and data protection notice.

By clicking on “OK” you confirm that you have taken note of the information on cookies, the data protection declaration and the publication details. You can also change your cookie settings for this website at any time.

Privacy settings

We place great importance on transparent information relating to all aspects of data protection. Our website contains detailed information on the settings you can select and what effect these settings have. You can change your selected settings at any time. Regardless of the selection you choose, we will not draw any conclusions regarding you as a person (except where you have explicitly entered your details). For information on deleting the cookies, please see the help function in your browser. You can find out more in the data protection declaration.

Change your privacy settings by clicking on the corresponding buttons

Necessary

Cookies essential for the system ensure that the website works correctly. Without these cookies, malfunctions or error messages may occur.

This website will:

  • Store cookies required by the system
  • Store the settings you make on this website

This site wil never do the following without your agreement:

  • Store your settings, such as the language selection or cookie banner, so that you do not have to repeat them in the future.
  • Evaluate visits anonymously and draw conclusions to help us to optimize our website.
  • Draw conclusions regarding you as a person (except where you have explicitly entered your details, e.g. in contact forms)

Convenience

These cookies make the website easier to use and save settings, for example, so that you do not have to repeat them every time you visit the site.

This website will:

  • Store cookies required by the system
  • Store your settings, such as the language selection or cookie banner, so that you do not have to repeat them in the future.

This site wil never do the following without your agreement:

  • Evaluate visits anonymously and draw conclusions to help us to optimize our website.
  • Draw conclusions regarding you as a person (except where you have explicitly entered your details, e.g. in contact forms)

Statistics

Statistics cookies enable us to evaluate the usage behaviour on the website anonymously – without enabling any conclusions to be drawn about you as a person. This enables us to measure the performance of the website and to improve it continuously to offer a better user experience.

This website will:

  • Store cookies required by the system
  • Draw conclusions regarding you as a person (except where you have explicitly entered your details, e.g. in contact forms)
  • Evaluate visits anonymously and draw conclusions to help us to optimize our website.

This site wil never do the following without your agreement:

  • Draw conclusions regarding you as a person (except where you have explicitly entered your details, e.g. in contact forms)

Of course, we will always respect the do-not-track (DNT) setting in your browser. In this case, no tracking cookies are set and no tracking functions are loaded.